This command allows you to set the limits of the map
projection.

Widget:
- There is currently no widget interface to this command.
Command:
- MAPLIMITS = LIMITS,LIM1,LIM2,LIM3,LIM4,LIM5,LIM6
ARGUMENTS :
- LIMITS: specifies whether the arguments lim1-lim6 indicate the
limits of the map based on corner points, points on the edge of the
map, angles, or the maximum useful area of the map.
- LIM1-LIM6: arguments specifying the map limits. The meaning of
these arguments and the number required are dependent on the value
of limits.
Examples :
- MAPLIMITS = MA
the maximum useful area produced by the projection is plotted. The
argumenss lim1-lim6 are ignored.
Notes :
- The default is MA.
- The use of this command requires some familiarity with the NCAR
Graphics EZMAP routines. For further information on setting map
limits, see the NCAR Graphics documentatain on the EZMAP routine
MAPSET.
back to index